Forum Replies Created
-
Posted in: Allo USB Bundle
-
28. November 2019 at 19:06 #47640
Hi all,
i have now successfully tested the following:
No change on SSID: Grundig 1042w
Passphrase:
change from
Upper an lower Alphanumeric an special characters
to
NumericA bing great Thanks for your support 🙂
With the special characters in the passphrase the Accesspint Mode fall back to deault AP settings.
Regards Björn
28. November 2019 at 17:26 #47631Hi,
my Password contains special character like @ and !
I test it now with a „standard“ Password.Regards
25. November 2019 at 21:54 #47598Hi Heiner,
i have exact the same issue.
Reloading advanced IEEE 802.11 management: hostapdNo /usr/sbin/hostapd found running; none killed.
failed!Hardware: Raspberry Pi 3 Model A Plus Rev 1.0
Here are my logs:
############################################
#### FILESYSTEM ####
Filesystem 1K-blocks Used Available Use% Mounted on
/dev/root 30419692 2904324 26250872 10% /
devtmpfs 215984 0 215984 0% /dev
tmpfs 220592 0 220592 0% /dev/shm
tmpfs 220592 7988 212604 4% /run
tmpfs 5120 4 5116 1% /run/lock
tmpfs 220592 0 220592 0% /sys/fs/cgroup
/dev/mmcblk0p1 42136 22857 19280 55% /boot
tmpfs 44116 8 44108 1% /run/user/1000#### LOAD AVERAGE ####
0.05 0.07 0.07 1/217 2548#### KERNEL ####
Linux Grundig1042w 4.19.66-v7+ #1253 SMP Thu Aug 15 11:49:46 BST 2019 armv7l GNU/Linux#### LINUX-VERSION ####
Distributor ID: Raspbian
Description: Raspbian GNU/Linux 9.11 (stretch)
Release: 9.11
Codename: stretch######################################################
Acesspoint Logs:
#### DNSMASQ Installed ####
Status: install ok installed#### HOSTAPD Installed ####
Status: install ok installed#### WiFi Interface Installed ####
8#### DNSMASQ Running ####
#### HOSTAPD Running ####
Thanks for Reply!
Regards Björn
-