flodo

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Back to forum
    Posted in: Allo USB Bundle
  • flodo premium
    1. Juli 2020 at 22:45 #49172

    Hi, thanks for the reply. I have successfully updated to 2.52. It is really crazy. Everytime I change something it works fine until I switch max2play of. Could it be something in the router settings that is incompatible? At first I forced fixed IP addresses of my raspberry pis. Through that it worked fine for the rest of the day, but the next day it didn’t work again. Then I noticed that some of devices are on 2.4GHz and some on 5Ghz, so I put everything on 5GHz and it worked again for a day. Now I am trying to mess with the channels of my router. So far, no luck. Really frustrating. …
    Cheers
    Florian

    flodo premium
    26. Juni 2020 at 23:48 #49099

    Hi, I have not picked up on it in December, but now with LockDown in UK I found some time to look at it again. I believed I had solved the problem by fixing the IP address but then I restarted everything having it switched off for a while and the erratic behaviour is back: When I start/reboot the raspberry pie I can access the web interface for a short while from the browser of my phone or iPad but after approximately a minute I cannot access it anymore. From a laptop (Mac or Windows) it still works fine. This is now without the squeezebox server running. Any help appreciated.
    Best
    Florian

    flodo premium
    7. Oktober 2018 at 1:01 #38410

    I do have the same issue. I have an rpi3 and an rpi0. My goal is to use the rpi3 as the server and the rpi0 as a spotify device for a bluetooth speaker.
    With the wifi installation I had no luck on either of the pis. whenever I saved the wifi configuration after accessing the pi from a computer directly through the access point the access point vanished and I could not check whether the setup was completed. After rebooting I can see the pis in my network but cannot access the m2p interface through a browser, neither through the max2play/ nor through the IP address. When I set up the system on the rpi3 through cabled network I managed to get everything set up and am even able to use it purely with wifi – only with the ip address though. Using the same SD card in the pi0 though no success. The pi only shows up on my router but I fail to access it.
    Any suggestions what to check? My IT skills are a bit rusty.
    Cheers
    Florian

    flodo premium
    7. Oktober 2018 at 0:22 #38409

    Thanks, commenting out dtoverlay=iqaudio-dacplus did the job for me too.

Viewing 4 posts - 1 through 4 (of 4 total)