barnosch

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • 30. November 2018 at 23:17 #42462

    check this section once again:
    #after installing of packages and automatic rebooting LCD works, but it is needed to change Driver#

    $ sudo nano /usr/share/X11/xorg.conf.d/99-fbturbo.conf
    #replace the line Driver „fbturbo“ with Driver „fbdev“, then ctrl+o, ctrl=x#
    $ sudo reboot

    in my case it was reset again to fbturbo instead of fbdev

    30. November 2018 at 12:49 #42439

    Kurzes Feedback.
    Funktioniert!

    Hab mir spontan ein Pi3 Modell A+ zugelegt und das aktuelle Image bootet problemlos.

    21. November 2018 at 12:45 #42203

    Danke für die Rückmeldung.
    Dann probier ich das evtl. mal.

    Hab es jetzt auch allerdings mit dem PiZeroW und einem 4″ TouchDisplay hinbekommen.
    Der PiZero hat sich nicht überreden lassen sich zu meinem Wlan zu verbinden
    (Der Hotspot ging, aber beim eingeben der Wlan Daten, gabs nur Fehler. WPS auch extra eingeschalten zum testen, ging auch nicht)
    Komisch. Das lief nämlich irgendwann genau in der Konfig mit dem Wlanstick schon. Anyway.

    5. Dezember 2017 at 21:17 #32799

    sadly no difference with the old image.
    So it is not a solution to downgrade.
    crap

    5. Dezember 2017 at 9:20 #32785

    Hi all,

    same issue for me.
    Only Squeezelite is activated.
    configured to hw:0
    Squeezeserver also running on this pi3, connected via Wlan.
    Have not yet tested if the other speaker (pi0w with justboom amp) is working correctly. Its located in the studio downstairs.

    But the issue only starts after i upgraded from 2.44 to 2.45
    Was working normally with a pi3 and Amp2

    But it only happens on one channel. (the right one, if you look to the terminals)
    Need to check if it is also happening while playing music, not tested yet, since it was so annoying that i pulled one cable to not destroy the expensive Klipsch Speakers.

    Will try to flash the system again but again with v2.44

Viewing 5 posts - 1 through 5 (of 5 total)