Connecting error after power blackout

Max2Play Home › Forums › SD-Card Imaging and getting started › Connecting error after power blackout

Viewing 2 posts - 1 through 2 (of 2 total)
  • Back to forum
    Posted in: SD-Card Imaging and getting started
  • Chrissoo premium
    15. Dezember 2017 at 23:26 #32985

    Hi, is there a proper way to get a reconnection to the lms on the raspi after a power blackout? There were power blackouts a few times and it always restarted after so that my Logitech squeezebox could reconnect to the max2play server on the raspi. It needed some more tries, but anytime it worked. But this time I get no reconnection after the blackout. I tried to disconnect and reconnect the power supply lots of times but it does not work.

    thank you

    Heiner premium
    18. Dezember 2017 at 10:19 #33003

    Hi Chrissoo,

    In order to rule out a possible hardware defect caused by these blackouts, please try first connecting your Pi to a screen via HDMI to see if it still boots normally. If this does not work, please try burning a fresh image and booting that.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Register here