bass control using sox and custom-convert.conf

Max2Play Home Forums Max2Play as Squeezebox (Player / Server) bass control using sox and custom-convert.conf

Viewing 3 posts - 1 through 3 (of 3 total)
  • 18. Februar 2019 at 20:17 #44515

    Dear forum,
    Help please !
    I am trying to attenuate excessive bass from my speakers. M2P on a pi 3b with LMS installed. I have created a custom-convert.conf and placed it in ‚\etc\squeezeboxserver‘ folder. The contents:

    # resampling to 24-192 and bass control

    flc flc * *
    # FT:{START=–skip=%t}U:{END=–until=%v}
    [flac] -dcs $START$ $END$ — $FILE$ | [sox] -q -t wav – -t flac -C 0 -b 24 – gain -1 rate -v -I -b 98 192000 bass -20 100

    It does not work ! The server log reports „[19-02-17 12:26:15.7282] Slim::Player::TranscodingHelper::_getCapabilities (178) Capabilities for flc-flc-*-*: syntax error in FT:{START=–skip=%t}U:{END=–until=%v}“.
    Can anyone see the problem here ? I have tried updating sox and flac (sudo apt-get install sox / flac).

    • This topic was modified 5 years, 9 months ago by willdebeest.
    22. Februar 2019 at 11:20 #44542

    Hi willdebeest,

    If you have not yet, please try reposting the request in the slimdevices forums. It’s largest community of Squeezebox users and a very active one, so you’ll most likely get a reply from someone who’s had a similar issue.

    22. Februar 2019 at 11:55 #44543

    I’ll try that, thanks.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Register here